







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
See the difference
Before
After
Before
After
Before
AfterWalk-In Showers & Shower Remodeling in San Francisco, CA
A walk-in shower remodel in San Francisco typically runs $6,500 to $18,000 for a full tear-out and rebuild, and $2,800 to $6,000 for a curbless conversion of an existing tub footprint. Most of that spread comes down to one thing: what’s behind the tile when the old surround comes off. In a city where a large share of the housing stock went up before 1950, it’s usually more than the homeowner expected.
We build walk-in showers the way the trade actually requires – sloped mortar bed or a waterproof foam pan, a bonded waterproof membrane over the whole wet area, and a proper drain connection tested before a single tile goes down. Our technicians have up to 19 years of experience, and they’ve opened enough San Francisco walls to know that the framing under a 1920s Outer Sunset bathroom is not the framing under a 1990s Mission Bay condo. Call (844) 797-6388 for a written estimate before any work starts. Our Bathroom Remodeling in San Francisco page covers the full-scope version of this work if you’re remodeling the whole room, and this page covers the shower specifically.
Every quote we write is a flat price with a written scope and a written warranty. Clause 1 of the Haven Standard is simple: the number goes in writing before anyone picks up a tool. That’s the reason we can tell you a range on this page and hold to it on the day.
Key Takeaways
- Walk-in shower remodels in San Francisco run $6,500 – $18,000 depending on pan type, tile, and what the tear-out reveals.
- Curbless (zero-threshold) conversions cost more because the floor framing and waterproofing have to be rebuilt to slope correctly.
- Pre-1950 homes in neighborhoods like Noe Valley and the Inner Richmond often hide galvanized supply lines and rotted subfloor that change the scope.
- You get a documented photo record of every visit as a standard deliverable – what we found, what we did, in sequence.
- Free second opinion on any written estimate you’ve received from another contractor. Bring it, we’ll read it line by line.

When You Need Walk-In Showers & Shower Remodeling
- Your shower pan is leaking into the ceiling below. In San Francisco’s dense multi-unit buildings, a slow pan leak shows up as a stain on a neighbor’s ceiling before it shows up in your own bathroom. If the ceiling stain is fresh and growing, that shower needs to come apart.
- You’re aging in place or planning for it. A curb you can step over comfortably at 45 becomes the thing you worry about at 70. A curbless walk-in with a linear drain and a built-in bench is the standard accessible design, and it doesn’t have to look institutional.
- The tile is failing at the joints. Cracked grout along the corners and a spongy feel underfoot usually mean the substrate got wet and the waterproofing is gone. Regrouting won’t fix it – the membrane has to be replaced.
- You inherited a 1980s or 1990s fiberglass surround. The one-piece units from that era are nearing the end of their service life, and the framing behind them frequently has moisture damage from the glue-up.
- You want a bigger shower in the same footprint. Removing a tub and converting the alcove to a walk-in often gains usable square footage in a bathroom where every inch counts, which describes most San Francisco bathrooms.
- Your water pressure or temperature swings. Old shower valves in pre-war homes can’t regulate pressure the way a modern thermostatic valve can. A remodel is the moment to replace the rough-in valve while the wall is open.
Our Walk-In Showers & Shower Remodeling Process
- Written scope and flat price first. We measure the shower, note the existing valve and drain locations, and give you a written price with a written scope before anything starts. That number covers demolition, framing repair up to a stated allowance, waterproofing, tile, fixture installation, and cleanup.
- Protected tear-out. We protect the hallway and floors, remove the old surround and pan, and inspect the framing, subfloor, and drain connection. If we find rot or a rusted drain line, we photograph it and bring you a change order – nothing proceeds until you sign it.
- Rough-in and waterproofing. New valve, new drain connection if needed, then a sloped pan, a bonded waterproof membrane bonded to the walls, and a flood test held overnight. We photograph the flood test. It’s in your record.
- Tile and fixtures. We set tile over the cured membrane, install a Kohler or Toto trim kit – the same fixtures we specify across our Bathroom Remodeling projects – and leave the grout to cure fully before the first shower.
- Final walkthrough and documented record. We walk the finished shower with you, test the valve and drain, and hand you the photo record of what we found and what we did. The 365-Day Done Right Promise backs the work: if it isn’t done right, we make it right.

Walk-In Showers & Shower Remodeling Pricing in San Francisco
Across San Francisco bathrooms, walk-in shower remodels land in these ranges. The number you get in writing depends on what the tear-out reveals and the finish level you choose.
| Scope | Typical range |
|---|---|
| Curbless conversion, existing tub footprint (labor + membrane + basic tile) | $2,800 – $6,000 |
| Full tear-out and rebuild, standard tile, standard pan | $6,500 – $10,500 |
| Full rebuild with linear drain, bench, and premium tile | $11,000 – $18,000 |
| Framing or subfloor repair from moisture damage (add) | $600 – $2,400 |
| New thermostatic valve rough-in (add, wall open) | $450 – $900 |
| Glass enclosure (framed or frameless, installed) | $900 – $3,200 |
What moves the number: pan type (a prefabricated waterproof foam pan is faster than a hand-built mortar bed), tile choice (porcelain and large-format over marble and mosaic), whether the drain has to move (San Francisco’s older drain layouts sometimes sit off-center and need relocating), and what’s hiding in the walls. We price the repair allowance up front so you know the ceiling before demolition – and a signed change order, not a surprise, is the only thing that changes that number.
What we don’t do is quote high to cover the unknown and keep the difference. The scope is written, the allowance is stated, and the photo record proves what was actually done. If you have a written estimate from another contractor, we’ll review it line by line at no charge – our Free Second Opinion standing offer – and tell you where the scope is thin.
Call (844) 797-6388 for a written estimate. We answer calls with a live person 24/7, and every visit includes a documented photo record.
FAQs – Walk-In Showers & Shower Remodeling
How much does a walk-in shower remodel cost in San Francisco?
A walk-in shower remodel in San Francisco costs $6,500 to $18,000 for a full tear-out and rebuild, or $2,800 to $6,000 for a curbless conversion of an existing tub. The lower end assumes a prefabricated pan and standard porcelain tile; the upper end covers a linear drain, a built-in bench, premium tile, and a frameless glass enclosure. Call (844) 797-6388 for an exact written price – the estimate is free.
Is it cheaper to repair or replace a failing shower?
Replace, in almost every case where the waterproofing has failed. Repairing tile or grout over a compromised membrane fixes the appearance and not the leak, and the water damage underneath keeps going. If the pan and membrane are sound and only the finish is tired, a resurfacing can make sense – but in a San Francisco bathroom where the substrate has been wet, replacement is usually the cheaper path over five years. Call (844) 797-6388 and we’ll look at it with you before you decide.
Can you convert a tub to a curbless walk-in shower?
Yes, and it’s one of the most requested conversions in San Francisco. A curbless shower needs the floor to slope to the drain, which means framing work under the shower and a bonded membrane built to that slope – so it costs more than a curb-in conversion. In a top-floor unit in a building like those around Russian Hill, we check the joist depth before confirming it’s possible. Call (844) 797-6388 to have the framing assessed.
Can you come today?
We can assess a leaking shower or a failed pan the same day in most cases, and a live person answers the phone 24/7. A full walk-in remodel is quoted in writing after the assessment, with work scheduled from there. Call (844) 797-6388 and we’ll tell you when we can be there.
What documentation do I get?
A signed written scope and flat price before work starts, a signed change order for anything that changes, a photo record of what we found and what we did on every visit, and a written warranty. The 365-Day Done Right Promise covers the work for a full year – if it isn’t done right, we make it right.
For the full-room version of this work – vanity, lighting, layout, and the shower together – see our main bathroom remodeling service. And if your project is part of a larger renovation, we handle the whole scope through our home services.
Call (844) 797-6388 for a free estimate on your walk-in shower remodel in San Francisco. The written price comes before anything else, and the photo record comes with it.
Written by the team at Rowan Construction Group San Francisco, serving San Francisco.


