







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Belgard Driveway & Pavers in San Francisco: What to Know First
Driveway and paver work on Belgard products in San Francisco is available through us as an independent Belgard service provider. Most residential jobs – a new Belgard paver driveway, a Belgard patio, or a repair and re-level of settled pavers – take one to three days of on-site work once materials are on hand, longer for full driveway replacements with base reconstruction. Pricing is written before any work starts, always: a flat number with a written scope and written warranty, not a “call for a quote” placeholder.
This page is for owners of Belgard hardscape – the paver driveways, patios, walkways, and pool decks in the Belgard line – who want the work done correctly by technicians who have handled these products across the city. Our technicians have up to 19 years of experience with Belgard and other hardscape systems. Call (844) 797-6388 to set up a free estimate.
How Belgard Products Fail – and How We Fix Them
Belgard pavers hold up well. What fails on a San Francisco property is almost always the install detail or the base, not the paver. Still, each Belgard line has its own weak points worth knowing before you call anyone.
- Belgard Catalina pavers – joint sand washout on sloped driveways. Catalina’s tighter face profile looks clean on a slope, but water concentrates in the narrow joints during heavy rain, and polymeric sand starts to wash out within a season or two on grades above 5 percent. We reset the joints with the correct polymeric sand for pedestrian and vehicular traffic and address the grade or drainage channel underneath so the sand stays put.
- Belgard Brussels Block – efflorescence and base settlement over clay-heavy soil. Brussels Block is a tumbled paver common on walkways and patios. When installed over Marin clay with too-thin base, the pavers rock and trap moisture, and white mineral bloom (efflorescence) appears on the surface. We pull the affected field, rebuild the base in lifts with proper compaction, and re-set the pavers so water drains away from the house.
- Belgard Mega-Arbel – shear failure at driveway aprons. Mega-Arbel’s larger face handles vehicle loads well, but where a San Francisco driveway meets the sidewalk apron, the transition from flexible paver to rigid concrete is a stress point. Cracking often starts there. We cut a clean transition, install the correct edge restraint, and pour or reset the apron so the pavers don’t lift at the joint.
- Belgard Catalina Slate – surface spalling when de-icing salts meet fog-wet mornings. Slate-textured pavers are popular for pool decks and entry walks. The San Francisco fog and occasional winter salt use on walks can leave the surface porous and prone to spalling in a freeze. We specify a penetrating sealer rated for the local climate and note which areas should not receive rock salt.
- Belgard Arbel and other driveway pavers – wheel-path rutting. On narrow San Francisco driveways with a single vehicle path, the pavers along the wheel line settle faster than the rest of the field. It’s a base and compaction issue, not a paver defect. We re-compact the subgrade, verify the base depth, and re-set the wheel path so the whole drive sits flat and takes the load evenly.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Our Belgard Driveway & Pavers Process
Every Belgard job here runs the same six steps. Nothing gets skipped.
- 1
Diagnostics. We walk the surface, check the base depth where possible, and identify which Belgard series is installed and what’s actually failing – base, joint, edge restraint, or surface.
- 2
Written price before any work. You get a flat number in dollars, a written scope, and a written warranty. If you have a competitor’s quote, we’ll review it line by line at no charge as a free second opinion.
- 3
Parts decision. OEM Belgard pavers where the original line is still in production (Catalina, Brussels Block, Mega-Arbel, and others). If a line is discontinued, we source a matching profile and tell you exactly how the match will differ before you sign.
- 4
The work. Base rebuilding in proper lifts, compaction, edge restraint, pavers set to grade, polymeric sand joints. Changes require a signed change order – work does not proceed without one.
- 5
The test. We water-test drainage, verify slopes, and walk the surface with you. Photo record of what was found and what was done is included on every visit.
- 6
The guarantee. Every job carries the 365-Day Done Right Promise. If it’s not done right, we make it right.
What Belgard Driveway & Pavers Costs in San Francisco

These are the ranges we write on estimates for Belgard and similar hardscape in San Francisco. Your number depends on the paver line, the base condition, and how much of the old surface has to come out.
| Work | Typical range |
|---|---|
| Belgard paver driveway installation | $8,260 – $21,240 |
| Paver patio installation | $4,130 – $12,980 |
| Driveway replacement (full removal and rebuild) | $5,900 – $16,520 |
| Concrete driveway installation | $5,310 – $14,160 |
| Asphalt driveway paving | $4,130 – $10,620 |
| Driveway sealing | $295 – $825 |
What moves the price: base condition (soft clay, past decking, or old concrete under the pavers), access on narrow San Francisco lots, whether drainage needs work, and the specific Belgard series chosen. The estimate is free and the price is written before anyone picks up a tool. Call (844) 797-6388 for an exact figure.
See the difference
Before
After
Before
After
Before
AfterWhy San Francisco Homeowners Call Rowan Construction Group San Francisco for Belgard Work
We’re an independent Belgard service provider, not a manufacturer or authorized dealer. What you get when you call us is written pricing before work starts – the discipline behind every job we quote, across all seven trades. The 365-Day Done Right Promise is printed on every page and backed by a real terms page. Crews are background-checked and uniformed, and a live person answers the phone around the clock.
Our sourcing depth matters here: we work with Belgard and Techo-Bloc pavers, and also carry the lines customers ask about across the property, including KraftMaid, Kohler, GAF, and PGT. If your Belgard paver driveway is one piece of a larger project, the same written-price discipline applies to every line on the estimate. Bring a competitor’s quote and we’ll review it at no charge.
FAQs

Belgard’s manufacturer warranty covers defects in the paver itself, not installation errors or base failure. If pavers crack from a bad base or joint washout, that’s an installation warranty issue, not a Belgard one. Our 365-Day Done Right Promise covers the work we perform. Call (844) 797-6388 to talk through your situation – estimates are free.
Usually yes. We source matching profiles from current Belgard lines and tell you exactly how the replacement will differ in color, texture, or dimension before you approve anything – in writing. You’ll see the match difference in the scope, not discover it on install day.
Repair is the right call when the base is sound and only a section is failing – joint washout, a few settled pavers, or one cracked field. Full replacement makes sense when the base has failed across the drive or the wheel path is rutted deep. We’ll tell you which you’re looking at in the free estimate, with the photo record to back it.
Most residential Belgard driveway installs run one to three days of on-site work once materials are delivered. Full replacements with base reconstruction and drainage work take longer. The timeline is in the written scope before the job starts, so you can plan around it.
When a permit is required for the work – driveway replacements, some structural base changes, and certain drainage alterations – we pull it and confirm the inspection passes. The written scope tells you up front what’s permitted and what isn’t. Call (844) 797-6388 for a free estimate and a clear answer on your property.
Contact Us for a Free Belgard Driveway & Pavers Estimate
If you’ve got Belgard pavers that are settling, washing out, or due for a full replacement, call (844) 797-6388 to schedule your free estimate. You’ll get a written price before any work starts, a written scope, a background-checked crew, and a photo record of the finished job. If you already have a competitor’s quote, bring it – we’ll review it line by line at no charge.
Written by the team at Rowan Construction Group San Francisco, serving San Francisco and nearby areas.












