







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Trusted Fence Installation for San Francisco Homeowners
Fence installation in San Francisco typically costs $4,130 – $10,620, and the number we hand you is a flat written price with a written scope before anyone digs a hole. That matters here more than in most cities. San Francisco lots are narrow, property lines are often surveyed differently than the neighbors assume, and a fence on a steep Bernal Heights slope is a different engineering job than the same footage on a flat Sunset lot. Our technicians have up to 19 years of experience reading those conditions, and every crew member is background-checked and uniformed before they arrive. Call (844) 797-6388 for a free estimate, and a live person answers.
What Our Fence Installation Service Includes
Fencing is one of our seven trades, and it gets the same written-price discipline as a kitchen remodel. Under Clause 1 of The Haven Standard, the price is written before anyone starts.
Wood Fence
Wood fencing covers the standard board-on-board, dog-ear, and horizontal-slat styles, usually in redwood or cedar for San Francisco’s damp, salt-laden air. You’ll want it when an existing fence has warped, gone gray to the point of rot at the base, or when a new property purchase has left you with a fence line that belongs to someone else. We set posts in concrete below the frost-and-moisture line the soil here demands, and we check the property line against the recorded parcel map before we lay out a single post.

Chain Link Fence
Chain link is the practical choice for a rear lot or a side yard where security and cost matter more than appearance, typically with galvanized or vinyl-coated mesh. You need it when a back gate needs to actually lock and the old chain link has rusted through at the tension bar. We spec heavier gauge for anything facing a public right-of-way and stretch the mesh tight enough that the fence doesn’t sag within a season.

Vinyl Fence
Vinyl fence installation runs $4,130 – $10,620 in San Francisco, and the range reflects how much of the job is gate work and how much grading the line requires. Vinyl holds up better than wood against fog and salt, which is why it shows up on outer-Sunset and Richmond District properties facing the ocean. We confirm the post spacing and wind rating before ordering panels, because an ocean-facing vinyl fence on an unsupported run will flex.

Aluminum Fence
Aluminum fence installation runs $4,720 – $11,800 and is the usual answer for a front-yard enclosure that has to look deliberate and still meet height limits. You want it when a wood front fence has rotted and the neighbor’s trash cans are now the view. We powder-coat or anodize the finish as specified, and we check the San Francisco front setback rules before laying out the run, since a fence that encroaches on the sidewalk clearance gets pulled by the city.
Iron Fence
Iron and steel fencing is heavier, welded, and built to last decades, typically on a masonry or concrete base. You choose it when you want the entry to a Victorian or Edwardian property to match the building’s original detail, or when security on a ground-floor window is the concern. We measure the base and mill the sections to fit rather than cutting on site, which keeps the powder coat intact at the joints.
Fence Repair
Fence repair covers post replacement, panel replacement, gate rehang, and the rot repair that shows up first at the bottom rail in a San Francisco fog belt. You need it before a leaning fence takes the gate with it, or before a storm season finishes off a post that’s been soft at the ground line for a year. We photograph what we find at the base and the hardware before we quote, and that photo record goes on your file as standard, not as an upgrade.
Privacy Fence
A privacy fence is a taller, closed-panel run built to block sightlines, usually paired with a gate and sometimes with a trellis on top. You want it when a neighboring deck or window now looks straight into your yard. We check the height against the San Francisco planning code and the lot’s zoning before we commit to a panel height, because an over-height fence is a neighbor complaint waiting to happen.
Fence Gates
Gates are the part of a fence that fails first, and they get their own line in our written scope. We hang driveway gates, pedestrian gates, and self-closing pool or side-yard gates, and we spec the hinges and latch for the actual load. If the gate needs a keypad or an opener, we coordinate the rough electrical with the run so the fence isn’t finished before the power is.
Commercial Fencing
Commercial fencing covers property-line security, dumpster enclosures, and ADA-compliant pedestrian gates for small commercial and mixed-use properties. We work from the site plan and pull the permits the property requires, and we schedule around business hours so the entrance isn’t blocked during open time. Commercial quotes include the line-item material list and the footing spec in writing.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Brands We Service for Fence Installation
Fence hardware and materials come from a range of manufacturers, and we’ve worked with enough of them to know where each one holds up and where it doesn’t. For gates and hardware, we spec brands whose hinges and latches we’ve seen survive a decade of San Francisco fog, and we know which powder-coat finishes chalk out early on an ocean-facing run. For anything that ties a fence into a Hardie-sided wall or a Hardie-trimmed gate frame, we match the trim detail so the fence and the house read as one build rather than two.
Where a fence meets a deck, a paver path, or a drainage run, we treat the material transitions the same way we treat them on a Hardie-clad addition or a Cambria-topped outdoor kitchen surround: the joint is specified, not improvised. Whether your fence ties to James Hardie trim, sits beside a new paver path, or needs hardware from a make we haven’t named here, we can help, and we’ll tell you plainly if a material is the wrong choice for the site.
Signs You Need Fence Installation Right Now
- Posts leaning after a wet winter. A post that shifts at the ground line usually means the concrete footing has cracked or the soil has settled around it. Waiting through another rainy season turns a post-and-footing repair into a full panel replacement.
- Rot at the bottom rail or post base. San Francisco’s fog belt keeps the lower six inches of a wood fence damp most of the year, and rot starts there first. Probe the base with a screwdriver; if it sinks in easily, the fence is past patching.
- Gates that drag, sag, or won’t latch. A gate that has dropped is telling you the hinge post has moved. Fixing the latch alone leaves the real problem in the ground, and a gate that won’t close is also a security gap.
- Rust bleeding through the finish on metal fencing. Rust at the welds or the tension bar means the coating has failed and the steel is now exposed to salt air. A localized repair is possible early; once the rust is structural, sections get replaced.
- A property line you can’t verify. If you’re not sure where the fence actually belongs, don’t build on an assumption. We check the recorded parcel map and the survey before layout, because a fence built a foot onto a neighbor’s lot in San Francisco is a real dispute.
Our Fence Installation Process – Step by Step
- 1
Site visit and property-line check. We walk the run, photograph the existing fence and the ground conditions, and confirm the property line against the recorded parcel map. On a sloped lot, we note the grade change per section, because post depth and panel height change with it.
- 2
Written price and written scope. Before any material is ordered, you get a flat written price, a written scope, and a written warranty. The scope lists the post spacing, footing spec, material, finish, gate hardware, and permit responsibility line by line, so you can compare it to another quote side by side.
- 3
Permits and scheduling. If the run needs a permit, we pull it and schedule the inspection. We coordinate the material delivery and confirm the crew date in writing, and you get a text confirmation rather than a phone promise.
- 4
Layout, excavation, and setting. We string the line, mark the post holes, and set posts in concrete to the depth the soil and load require. On a steep run we step the panels rather than racking them, which keeps the fence level across the slope and the gate square.
- 5
Install, photo record, and walk-through. We hang the panels and gates, then walk the finished run with you and hand over the documented photo record of what we found and what we did. The 365-Day Done Right Promise is printed on the paperwork: if it isn’t right, we make it right.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Fence Installation Cost in San Francisco?

A typical wood or vinyl fence installation in San Francisco runs $4,130 – $10,620 depending on footage, height, gate count, and how much of the line is on a slope. Aluminum fencing runs $4,720 – $11,800, reflecting the extra hardware and the tighter tolerance a metal run demands. A short privacy run with one gate sits near the low end; a full perimeter with a driveway gate and stepped panels on a Bernal Heights or Noe Valley grade lands near the top.
What moves the number: total linear feet, fence height and whether the zoning allows it, post spacing and footing depth, gate count and hardware, material choice, and whether a permit and inspection are required. Steep lots and rocky soil add labor. A front-yard run that has to meet the San Francisco sidewalk-clearance rule may need a different panel height than the rear.
How to avoid overpaying: get the written scope, not just a total. A quote that says “fence, installed” hides the footage, the post spacing, and the gate hardware, which is exactly where a low bid gets its number back. Bring a competitor’s written estimate and we’ll review it line by line at no charge, the same Free Second Opinion we offer on any written estimate. Every Rowan quote is a flat price with a written scope and written warranty, and no work proceeds on a change until the change order is signed. Call (844) 797-6388 for an exact quote; estimates are free.
Fence Installation Near San Francisco – Our Service Area
We install and repair fences across San Francisco and the surrounding cities, including Fence Installation in Emeryville, Fence Installation in Berkeley, Oakland, Alameda, Albany, Piedmont, El Cerrito, Richmond, San Pablo, South San Francisco, and Millbrae. Response times depend on the job and the schedule, and we confirm the visit window in writing rather than guessing at it. If you’re just starting to price the work, start with our Fence Installation in San Francisco overview, then bring us the written estimate you have.
Serving San Francisco, CA – Our Local Coverage Area
We serve San Francisco and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Fence Installation in San Francisco

Fence installation is the design, layout, excavation, and build of a new fence line, including posts, panels, gates, and the finishing hardware, done to a written scope. It differs from fence repair, which fixes an existing run rather than building a new one. In San Francisco it also involves checking the property line and the front setback before layout, because the lot rules here are strict. Call (844) 797-6388 to schedule a free estimate.
Most residential runs take one to three days on site, depending on footage, slope, and gate count. A short privacy run with one gate can finish in a day; a full perimeter on a stepped lot with permits and inspection can stretch to a week or more from start to final walk-through. We put the schedule in writing with the quote, so you’re not guessing. Call (844) 797-6388 for a timeline on your specific run.
Fence installation in San Francisco runs $4,130 – $10,620 for wood or vinyl, and $4,720 – $11,800 for aluminum, depending on footage, height, gates, and grade. A simple rear run sits near the low end; a full perimeter with a driveway gate and stepped panels sits near the top. Every Rowan quote is a flat written price before work starts, with a written scope so you can compare it to another bid. Call (844) 797-6388 for an exact quote; estimates are free.
No, not without a signed change order. The written price is the price, and no work proceeds on a change until the change order is signed, which is the discipline that has kept Rowan’s projects within a few percent of the agreed cost. If we uncover something the scope didn’t anticipate, like a rotten post footing or a buried utility line, we show you the photo record and put the change in writing before touching it. Call (844) 797-6388 with any questions about the quote.
When the run requires a permit, yes, we pull it and schedule the inspection. San Francisco requires a permit for many fence and gate installations, and a front-yard fence has to meet the sidewalk-clearance and height rules in the planning code. We build the permit responsibility into the written scope so it isn’t a surprise line later. Call (844) 797-6388 and we’ll tell you what your project needs.
Every fence we install is covered by the 365-Day Done Right Promise: if it isn’t done right, we make it right. The guarantee is printed on the paperwork you receive and backed by a terms page, not an asterisk, and it sits alongside the written warranty in your scope. If a post settles or a gate drops within the year, we come back and correct it. Call (844) 797-6388 to talk through the warranty on your job.
Clear the run of plants, furniture, and anything stored against the existing fence, and make sure we can reach the line from your side of the property. If a neighbor shares the line, a quick conversation before the crew arrives saves a lot of friction, and we’ll confirm the property line against the recorded map so nobody is guessing. Move vehicles clear of the gate location. Call (844) 797-6388 if you’re unsure what to move or clear.
Schedule Your Fence Installation Service in San Francisco Today
Call (844) 797-6388 to schedule your free estimate for fence installation in San Francisco. You’ll get a flat written price, a written scope, and a written warranty before any work starts, and a live person answers the phone 24/7. Bring a competitor’s quote and we’ll review it line by line at no charge. No obligation, no pressure, just the number in writing.
Written by the team at Rowan Construction Group.












