







Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Trusted Windows & Doors for San Francisco Homeowners
If your windows are fogged, your sliding door sticks, or you can hear the 38-Geary bus from inside your living room, the glass and frames are the weak point in the house. Windows and doors in San Francisco live under conditions that punish cheap assemblies: salt air off the Pacific, fog that keeps the Sunset and Richmond districts damp for weeks, and wind that hits Twin Peaks and Diamond Heights with real force. Our technicians have up to 19 years of experience with the specific stock here – single-pane aluminum sliders from the 1950s and 60s, double-hung wood windows in Edwardians, and the mixed retrofit work that follows. We put a flat written price in front of you before anyone picks up a tool, backed by The Haven Standard. Call (844) 797-6388 to schedule a free estimate.
What Our Windows & Doors Service Includes

Six service lines cover almost every job we’re asked about in San Francisco. Each one starts with a written scope and ends with a photo record of what we found and what we installed.
Window Installation
Window installation means cutting, framing, and setting new units where windows didn’t exist or where the rough opening changes. It’s the right call for an addition, a converted garage, or a room where the existing opening is the wrong size for any standard unit. We flash and seal to San Francisco’s wet-weather realities first, then finish the interior trim to match the surrounding woodwork. You get the rough opening dimensions and the finished dimensions in writing before we order.
Door Installation
Door installation covers new openings and slab or pre-hung swaps on entry, interior, and closet doors. If your front door has swollen shut since the last rainy season, or the frame has pulled out of square in a settling Victorian, a new door set right is often less expensive than repeated planing and weatherstripping. We hang, shim, and align the strike plate so the door latches with one finger, then check the threshold seal against a hose test.
Window Replacement
Window replacement is a full-frame or pocket swap of existing units, and it’s the most common job we do in San Francisco. We measure every opening individually because no two are square in buildings from 1900 to 1975, then specify the frame material and glass package to match the exposure. Rot in the sill or header gets documented with photos before we quote, so you’re not surprised by a change order once the old unit comes out.
Impact Windows & Doors
Impact-rated assemblies use laminated glass that holds together on break, which matters on upper floors and on any window facing a sidewalk or common area. San Francisco doesn’t impose a coastal impact mandate the way parts of Florida do, but homeowners here choose impact glass for sound control, for ground-floor security, and for windows over occupied space. We specify the rating and show you the manufacturer’s documentation before ordering.
Energy-Efficient Windows
Energy-efficient windows pair a low-e coating, argon or krypton fill, and a thermally broken frame to slow heat loss and cut solar gain. In San Francisco’s mild, damp climate the gain comes from reduced condensation and quieter rooms more than from heating bills. We match the glass spec to the orientation: west-facing glass on Potrero Hill gets a different coating than a north-facing bedroom in the Avenues, and we explain why in one line on the quote.
Sliding & Patio Doors
Sliding and patio doors are the large glazed units that open to a deck, yard, or light well. When the track is worn or the rollers flat, the door drags and the seal fails, and water gets in at the threshold. We replace the unit or rebuild the track and rollers depending on condition, and we always check the threshold pan and weep holes, because the slope on a 60-year-old installation is where leaks start.
Styles & brands we work with
- Kitchen remodeling
- Bathroom remodeling
- Home additions & ADU
- Roofing
- Windows & doors
- Driveway & pavers
- Fence
Brands We Service for Windows & Doors
We specify and install James Hardie fiber cement trim and fascia around window and door openings on San Francisco exteriors, where painted wood trim swells, checks, and repaints every few years. The Hardie product holds a paint line in coastal fog and doesn’t rot at the sill, which matters most on the west side of the city. We also handle KraftMaid and Wellborn cabinetry when a window or door replacement touches a built-in or pantry wall, so the millwork lines up cleanly with the new frame.
Sourcing across fifty-plus vetted brands means the written quote carries honest numbers instead of a padded allowance. We’ll tell you when a mid-grade unit suits the exposure and when the premium one is worth the difference, and we name the spec in the scope so you can compare it to any other bid
Signs You Need Windows & Doors Right Now
- Fog or condensation between the panes. Fogged glass means the seal on the insulated unit has failed, and the window no longer insulates as rated. The glass needs replacing even if the frame is sound, and waiting lets moisture work at the frame edges.
- A door that sticks, drags, or won’t latch. A door that has swollen or dropped is usually telling you about frame movement or a failing threshold. Left alone, the misalignment wears the hinges, widens gaps, and lets water and air into the wall cavity.
- Water stains or soft wood at the sill or header. Rot at a window opening is a warning about the flashing and seal behind it, not just the trim. Press a screwdriver into the sill – if it sinks, the repair has moved past paint.
- Drafts, cold spots, or street noise you can hear clearly. Single-pane aluminum units in San Francisco’s older buildings transmit both, and the fix is usually the glass package and the weather seal. A new unit with a proper seal cuts the noise and the condensation together.
- A slider that jumps the track or won’t lock. Worn rollers and a bent track are a common failure on patio doors here, and a door that won’t lock is a real problem on any ground floor. We check the rollers, track, and latch as one system before recommending a full replacement.
Our Windows & Doors Process – Step by Step
- 1
Free in-home measure and condition check. We measure every opening, check the sill and header for rot with a probe, and note the exposure – wind-driven rain side, sun side, street-noise side. You get the findings in plain terms, and the photo record starts here.
- 2
Written flat price and written scope. Under Clause 1 of the Haven Standard, the price is written before anyone starts. The quote names the frame material, the glass spec, the trim detail, and the warranty in plain language, so you can line it up against any other bid.
- 3
Free second opinion, if you want one. Bring a competitor’s written estimate and we’ll review it line by line at no charge. This is where homeowners catch a low bid that leaves out flashing, trim, or disposal.
- 4
Order and install with a documented photo record. We order to the measured dimensions, protect the interior, and set each unit with new flashing and sealant at the sill and head. Every visit includes photos of the rough opening and the finished seal, and no change proceeds without a signed change order.
- 5
Final walkthrough and the 365-Day Done Right Promise. We test every latch, lock, and slide, and show you the seal lines and the written warranty. If something isn’t right in the first year, we make it right under the 365-Day Done Right Promise.
See the difference
Before
After
Before
After
Before
AfterHow Much Does Windows & Doors Cost in San Francisco?

A typical window replacement in San Francisco runs $5,310 – $17,700 depending on the number of openings, the frame material, and the glass package. A full impact window installation runs $9,440 – $29,500, since impact-rated laminated glass and heavier frames cost more per opening. Those numbers are the ranges we quote here, and they reflect the real market for this city’s housing stock.
What moves the price: the number and size of openings, the frame material (vinyl, fiberglass, wood-clad aluminum), the glass spec, and how much rot or flashing repair the rough opening needs once the old unit is out. Upper-floor access, historic-district trim requirements, and lead-safe handling in pre-1978 buildings also affect the number. To avoid overpaying, compare the glass spec and frame material, not just the total, and check that flashing, trim, and disposal are in the scope.
A free estimate from us includes the per-opening measurements, the written scope, the glass spec, and the warranty in writing. Call (844) 797-6388 for a flat written price before any work starts.
Windows & Doors Near San Francisco – Our Service Area
We work across the San Francisco service area, from the Sunset and Richmond districts out to the Excelsior, and into neighboring cities including South San Francisco, Millbrae, Daly City, and Oakland. We also cover the East Bay through our Emeryville service area and Berkeley service area, and the surrounding towns of Alameda, Albany, Piedmont, El Cerrito, and Richmond. Most estimates are scheduled within a few days of your call, and a live person answers the phone around the clock to book one.
Serving San Francisco, CA – Our Local Coverage Area
We serve San Francisco and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
Frequently Asked Questions – Windows & Doors in San Francisco

Windows and doors covers the glazed and hinged openings in your home – window installation, door installation, window replacement, impact windows and doors, energy-efficient windows, and sliding and patio doors. It includes the frame, the glass, the flashing and seal, and the interior trim. If the job touches a remodel or an addition, we fold it into the larger scope so the trades line up.
A single door swap is usually a one-day job, and a whole-house window replacement typically takes two to four days depending on the number of openings and how much flashing or rot repair the openings need. Upper-floor access, historic trim, and lead-safe handling in older San Francisco buildings can add time. You get the schedule in the written scope before we start.
Window replacement in San Francisco runs $5,310 – $17,700, and impact window installation runs $9,440 – $29,500 depending on the number of openings, frame material, and glass package. Rot repair at the sill or header, upper-floor access, and historic trim requirements can push the number higher, and we document any of that with photos before quoting. Call (844) 797-6388 for an exact quote – estimates are free.
Yes. We install and service James Hardie fiber cement trim and fascia around window and door openings, and we work with the common window and door makes in San Francisco homes. Whether you have James Hardie or any other make, we can help – the written quote names the exact product and spec so there’s no guesswork.
A broken window, a door that won’t secure, or water coming in at a failed seal can be handled as an urgent call, and a live person answers the phone around the clock to book it. We’ll board, secure, or seal the opening to stop further damage, then schedule the permanent repair. Non-emergency replacements are scheduled as normal planned work.
Every installation carries the 365-Day Done Right Promise: if it isn’t done right, we make it right, backed by The Haven Standard and a written warranty on the quote. The manufacturer’s product warranty runs separately and we document it for you. You also get the photo record of the rough opening and finished seal as standard on every visit.
Clear the area around each window and door and move fragile items away from the work zone – we protect floors and furnishings but a clear path saves time. Expect some dust and noise, and plan for the crew to have interior access to each opening. We’ll confirm the schedule and the access details in writing before the day, and any change is handled with a signed change order first.
Schedule Your Windows & Doors Service in San Francisco Today
If your windows are fogged, your doors stick, or you’re ready to price a replacement, call (844) 797-6388 to schedule a free estimate. You’ll get a flat written price, a written scope, and a written warranty before anyone picks up a tool, backed by the 365-Day Done Right Promise. A live person answers around the clock. No obligation, no pressure – just the number in writing.
Written by the team at Rowan Construction Group.












